Skip to content

Spiral Engineering — Parameter Setting

Adjust professional light parameters: Top Trim, Low-end Trim, PWM Frequency, Bottom Trim, and Transition time.

Admin required · iOS only

You must have management privilege to use Parameter Setting. See the Spiral Engineering overview for how to gain access.

Steps

  1. Select Parameter Setting.
  2. Choose a light or group to set the parameter for.

  3. The current parameter values are listed.

    Note

    Parameter values may not match those on each light in a group, since groups contain multiple lights.

  4. Set Top Trim.

  5. Set Low-end Trim.
  6. Set PWM Frequency.
  7. Set Bottom Trim.
  8. Set Transition time, then select Send to apply the new parameters to the lights.

Power-cycle after setting

Power-cycle the lights after all parameters have been set.